Issues with OG's 24x36 print packaging
Issues with OG's 24x36 print packaging
After getting a couple oversized offsets and the recent Vote, I've noticed that OG still uses the same kraft paper size they roll in the usual 18x24 prints. It's not too bad, but since these 24x36 prints are larger it is more likely to get creased edges after moving up and down the tube during transit because the kraft paper isn't covering the sides of the prints as much as it did to the 18x24 prints. Although they do use 2 sheets of kraft paper rather than one, the kraft papers aren't attached to each other so it's likely that they'll push in towards each other when rolled together. Shall we propose a better technique for these oversized prints? I think an easy solution would be to prevent the rolled print from moving up and down the tube by just stuffing it with kraft paper or tissue like some of us do here...
I would agree. Tragically, my vote print fell victim to exactly what you describe. The damage wasn't too bad, so I'm going to keep it, but I just don't want the same thing happening to my Obama print.
"Two things are infinite: the universe and human stupidity; and I'm not sure about the the universe."
-Albert Einstein
-Albert Einstein
Re:
Xpoc wrote:I would agree. Tragically, my vote print fell victim to exactly what you describe. The damage wasn't too bad, so I'm going to keep it, but I just don't want the same thing happening to my Obama print.
Yup. Same here. I didn't bother contacting OG, but if my Obama is the same way, then you can best believe i'm gonna let them know.
conartstudio wrote:the majority here enjoy art, the majority on EB enjoy profiting off of art. people become ruthless when money is involved.
- mrxscarface28
- Giant
- Posts: 1433
- Joined: Mon Dec 11, 2006 4:30 pm
- Location: Tustin, CA
Re:
mrxscarface28 wrote:Yea .... I have a couple of dents to the outer edge too ... nothing that bad though.
I would also try ironing the print. I have had some great success ironing rag paper and alike with an iron set to a low setting and kraft paper or butcher paper on both sides of the print. I do it very slowly on a flat large surface (clean floor) and keep the iron moving at all times. ALWAYS TEST A SMALL AREA FIRST TO SEE HOW
THE PAPER REACTS.
May sound drastic, but like I said, I've done this a few times and it has worked very well on non-print areas such as the edges. This was recommended to me by some one at BLK/MRKT Gallery when I received a slightly damaged Kinsey.
PROTECT ME FROM WHAT I WANT